- #Rubbermaid fasttrack system instructions install#
- #Rubbermaid fasttrack system instructions plus#
- #Rubbermaid fasttrack system instructions series#
#Rubbermaid fasttrack system instructions install#
Rubbermaid storage FastTrack is specially designed to be installed on drywall so if you have brick, cement or cinder block walls you will need to buy additional hardware and install the system differently. Tradesmen have also used FastTrack in their work vans to keep things organized and this seems to work well. Yes, great options would be the basement, laundry room and pantry, although shelving will be your main priority so the Rubbermaid wire shelving range might be more suitable depending on your requirements. You will also limit yourself to only being able to hang things from each stud as opposed to across the whole rail if you use the system properly.Ĭan I use the Rubbermaid FastTrack system anywhere other than the garage? You could mount the accessories into a stud but the screws for this are not provided.
#Rubbermaid fasttrack system instructions series#
Please see our other article in this FastTrack series to find out more about “Rubbermaid FastTrack Shelving”. You will need 3 pieces of vertical track that are sold separately along with the gripper that snaps onto the rail, as well as 3 brackets, again sold separately. How do I attach the wire shelves to the rail? Snap on the cover and then you are ready to snap on your accessories. Drill the remaining pilot holes, insert the wall anchors, hold the rail in position and screw into the wall. Level your rail and mark the rest of the drill holes using a pencil through the pre-drilled holes in the rail. To install it, use your stud finder to locate your studs, drill a pilot hole into the stud where you want the end of the rail to be, insert the wall anchor and screw in one end of the rail. The rail is the only part of the system that is attached to the wall. What tools do I need to install the Rubbermaid FastTrack rail?Īll you need for quick installation is a level, a drill (and 1/8″ and 3/8″ bits), a stud finder and a screwdriver.
#Rubbermaid fasttrack system instructions plus#
If you bought one of every accessory, plus all the rails needed to hang them on, it would cost about $450. If I bought every accessory, how much would it cost? Each accessory typically holds 50 lbs but you will need to check each one individually to ensure it is fit for the purpose you intend. The 84″ rails can hold slightly more weight than the 48″ rails – 2000 lbs v 1750 lbs. => Click HERE to let Rubbermaid solve your garage storage problems Click HERE for more details Click HERE for more details Click HERE for more details <= At the very least you will need to buy one or more rails and a few hooks, shelves or racks from the wide range of accessories to get your garage organization started. The rails and accessories are all purchased separately making the system completely customizable. It is specifically designed for drywall installation. Essentially it is just a wall-mounted rail that you snap a bunch of hooks onto, that then hold your tools and equipment off of the garage floor. The Fast Track system by Rubbermaid is a garage organization system. What exactly is the Fast Track Rubbermaid system?